Body Finish is a very high-quality and fast drying 1-component acrylic lacquer, specially developed to spray new or repaired sheet metal as well as parts of machines giving them an OEM finish.

Body Finish has been specially developed for the automotive, truck and agriculture sector where it is the ideal solution for finishing repaired or (partly) replaced sheet metal such as inner-skin panels, back panels, boot floors, interior of front and rear panels, but also A-pillars, etc.
Besides, Body Finish is also perfectly suited for being used in industrial applications, for example as machine paint or temporary anti-corrosive repair lacquer.

Body Finish owes its high value to the fact that it puts an end to the long drying and evaporation times of water-based lacquers. Body Finish is compatible with most paint systems, both water-based and solvent-based. The product is ready-to-use, thus putting an end to mixing times as well as disposal of lacquer surplus which is considered as chemical waste. Moreover, no spray-gun has to be cleaned when using Body Finish.

Body Finish is suited for being used on both large and small surfaces since the aerosol is provided with two flat spray nozzles with different capacity. The product is deliverable in 4 colours: green (7033), beige (7034), grey (7042) and graphite blue (7021).

• Base:Acrylic resin
• Density:749 kg/m
• Consistency:Liquid (ready-to-use in aerosol)
• Solvents:Organic solvents
• Flash point:< 0C
• Temperature resistance:Up to 120C
• UV resistance:Excellent
• Water resistance:Good
• Solvent resistance:Good, in the case of brief contact and after full cure
• Application conditions:+15C to +30C
• Type of surface:Ferrous and non-ferrous metals, layers of paint, conventional primers, intact existing paintwork
• Surface preparation:The surface must be clean, dry and free of dust and grease. Lightly sand the surface (matt) and then clean with InnotecMultisol. Clean plastic surfaces with InnotecRepaplast Cleaner Antistaticand pre-treat them with InnotecRepaplast Primer.
• Application method:Shake can well during 2 minutes before use. Spraying distance 10-15 cm. Apply two smooth layers. After use, invert can and spray until clear to clean the nozzle.
• Dust dry:After 5 to 10 minutes (20C / 65% relative humidity)
• Curing time:2 hours, depending on the layer thickness (at 20C / 65% relative humidity)
• Recommended layer thickness:Two dense and evenly sprayed layers (min. 40 dry)
• Sandability:Excellent after 1 hour (at 20C / 65% relative humidity)
• Paintability:Can be painted over wet-on-wet after 20 minutes (at 20C / 65% relative humidity) with almost every modern paint system
• Cleaning of materials used:With InnotecMultisol
• Cleaning of hands:With InnotecPower Scrubsor with InnotecSafe Hand Clean Plusand water
• Shelf life:2 years in original, unopened packaging
• Storage conditions:Store cool and dry
• Type of batchcode:F
• Other details:Spray capacity black-and-yellow nozzle: approx 1,2 g/s
  Spray capacity red-and-black nozzle: approx 3,0 g/s
  Extremely high impact-resistance after curing
• EAN Code:5400563011317