Description

Restore proper rear suspension performance with the MEYLE Rear Integral Link, a direct replacement for the factory rear integral link on applicable RWD Tesla Model S vehicles.

The integral link is a key component of the rear suspension, helping maintain proper suspension geometry and wheel control as the suspension moves through its range of travel. A worn integral link can contribute to clunking or knocking noises, loose handling, and excessive suspension play.

This part fits either the left or right rear side and is sold individually. Replacement in pairs is recommended.

Key Features

• Direct replacement for the rear integral link
• Fits left or right rear side
• High-quality MEYLE replacement component
• Helps restore proper rear suspension geometry
• Helps address worn or failed suspension components
• Same part used on both sides
• Replacement in pairs recommended
• Sold individually

Product Details

Tesla’s parts catalog identifies 6006895-00-A as the rear integral link assembly for Single Motor Model S vehicles with air or coil suspension, with a required quantity of two.

Fitment

Tesla Model S

• 20122021
• RWD / Single Motor
• Rear suspension
• Left or right side

Important fitment note: Tesla used a different rear integral link, 1021422-00-B, for Performance Plus and Dual Motor applications. The OE 6006895-00-A is specifically identified for the applicable Single Motor/RWD configurations.

Tesla OE Reference

• 6006895-00-A
• 600689500A

EVANNEX Ordering Guide

Sold individually replacement in pairs recommended.

The rear integral links operate under similar loads and driving conditions on both sides of the vehicle. If one link is worn, replacing both sides at the same time can help maintain balanced rear suspension performance.

Replacing one side:

• 1 MEYLE 6006895-00-A Rear Integral Link
• Tesla OE: 6006895-00-A
• Fits either the left or right side

Replacing both sides Recommended:

• 2 MEYLE 6006895-00-A Rear Integral Links
• Tesla OE: 6006895-00-A
• 1 Left
• 1 Right

Important: There is no separate left- or right-side MEYLE part number for this application. The same part is used on both sides.

Installation Note

After replacing rear suspension components, a four-wheel alignment is recommended to verify proper suspension geometry and help prevent uneven tire wear. EVANNEX also recommends an alignment following control-arm, bushing, or ball-joint replacement.