The rocker panel is the most vulnerable area on your vehicle when off-road and one of the most costly to repair. Protect your investment with a pair of RCI heavy-duty4Runner rock sliders.

RCI sliders utilize a full frame support mounting plate which protects your frame from damage and provides an extremely rigid attachment for the sliders by using multiple bolt locations all across the frame.

These will help protect the truck off-road and in the parking lot, and are still very functional as a step if needed.

FEATURES:

• Protects rocker panels and doors
• Utilizesa 2 square main tube which is far stronger than 1.75 round tube used by competitors
• 1.75 DOM outer rails for uncompromised strength
• Heavy duty 1/4 gussets on all legs
• 45 degree mitered main tube ends provide a superior aesthetic appearance as well as more functional design that wont hang up
• Full length 1/4 frame plates provides up to 15 mounting points, guaranteeing a slider as strong or stronger than anything else on the market
• Fully compatible with both KDSS and Non-KDSS equipped trucks
• Easily capable of supporting the entire side of truck for lifting with hi-lift, or sliding on rocks
• Standard with 20 degree upward angle, creates a low profile with maximum ground clearance
• Direct bolt on addition to existing mounting locations, no drilling required
• Available bolt on tread plate for step surface provides many benefits
  • Added safety for kids and pets getting in and out of the vehicle
  • Added protection to rocker panels from rocks and debris thrown from tires
  • Dimpled surface gives added grip and provides structural rigidity to the slider
  • We recommend 5 Degree angle with this option, for flatter step surface
• Easy install with only basic hand tools
• Available with our heavy duty black textured powder coat finish
• 4Runner rock sliderscoatedwith an epoxy primer for an exponentially more durable finish than competitors.
• In-housepowdercoating forbetter quality and shorter lead times for the same cost!
• Grade 5 & 8 hardware provided where applicable
• Standard with our signature low profile rear kickout

*Not compatible with Limited model 4Runner without removing or cutting the plastic rocker trim.

*Does not work with XREAS equipped models

MADE IN USA

Comparison of standard Hot Roll Electric Welded (HREW) steel tubing vs. Drawn Over Mandrel (DOM) tubing.

*Approximate mechanical specs for engineering design, may vary slightly depending on the manufacturer.

**Certified specs provided by RCI Offroads DOM supplier