If you feel that the warning light effect of your brake lights is not obvious enough, but you don’t want to replace new lights, then adding a flashing strobe light controller is your best choice!

AUXITO’s led flash strobe controller is suitable for all 12-24V vehicles with brake lights installed, adding a strobe mode to your brake lights and perfecting the early warning function for vehicles behind. After installation, when you operate the brakes, your brake light will flash 4 times in a row, then flash 4 times slowly, and finally return to normal flashing. Especially when there is traffic jam and frequent braking at night, it has a stronger warning effect, effectively avoiding rear-end collision accidents. Whether driving at night or in rainy and foggy weather, compared with ordinary brake light effects, the strobe visual warning is more obvious, which improves daily driving safety!

Besides, this strobe light controller only needs to be simply pasted and installed, connected with two wires, and ready to use at any time!

Specifications& Fitment

Product include: Strobe light controller*4, double-sided tape*4

Color: Black

Materail:ABS

Voltage: 12-24V

• Red connect to positive
• Black connect to negative

Flash mode:Quick flash for 4 times, slow flash for 4 times, and then Lighting normally.

Function: After installation, the originally always on light can have a strobe function

Suitablefor: Tail light,brake light etc.

Fitment:it can be widely applied to all types of carsbrake lights with 12-24V, such as cars, trucks, motocycles, electric bicycles and more.

TOP FEATURES

Safety Improvement

Improve the warning function of rear vehicles and avoid rear end accidents as far as possible.

Suprior material

Made of high superior ABS material with durable and waterproof functions.

Easy installation

Double side tape is included for an easier installation.

Waterproof

Complete sealing technology with better waterproof and short circuit protection.

Note

When you connect the led flash strobe controller, the end marked “in” is connected to the product, and the end marked “out” is connected to the power source.(Please make sure toconnect them in this order, otherwise it will be useless.)